Page last updated May 30, 2018 @ 11:04pm
NGV24 and NGV24-SW
optional switching to read two individual wires
AND REPLACED WITH NGV25
POWERmeter 6 Ammeter
digital LED panel meter kit, prewired
Displays Volts, Hertz, Amps, hours
(for use with branch circuits or
with power company service up to 600A)
Use the similar NGV25 that displays both Amps and kilo Watts
Don't operate your backup or alternative electric power system blind, risking damage to your power source and/or appliances! Install this meter so you can see everything that is happening. Perfect for monitoring parameters when your transfer switch or panel does not have meters. The Amp display will show if you are overloading the circuit and the Voltage and frequency (Hz) displays can be used to verify the power source is operating properly. An optional selector switch is available so that you can directly read the load on each hot leg of a standard split-phase North American power system. For regions that do not use a split-phase system such as most of Latin America and Europe the switch is not needed. This meter works on 60 Hz North American power systems and 50Hz systems in other regions.
Unlike analog meters that can only be accurately read over a limited fixed range this digital power meter can display both small values of an individual circuit AND large values of the whole utility service.
5 DISPLAY FUNCTIONS IN BRIGHT RED EASY TO READ LEDs
- Voltage - accurate from 165V to 275V, ±1 V
- Frequency (Hertz) - 40Hz to 70Hz, ±0.2 Hz
- Current (Amps) - 0kW to 9999A, ±1 A
- Current Run Time (hours) - 0 to 999, since last circuit turn-on
- Total Operating Time (hours) - 0 to 9999, since first time meter energized
- Optional selector switch to individually read L1 and L2 loads or the total load
- Pre-wired and installed in 3-gang box for easy wall mounting
- Includes 3-gang steel box, pre-punched stainless steel wall plate, 18" ENT conduit and fittings
- Current sensors for mounting on cables
This new line of instruments is designed as a cost effective alternative to the traditional separate analog panel meters and can replace up to five meters. An electronic solid-state design ensures maximum durability against vibration while a microprocessor based digital sampling technology provides maximum accuracy and stability in a wide range of environments. The normal display shows Voltage, Hertz and Amps and a second page shows the other two hour parameters. Meter comes pre-programmed to match included sensors.
Standard current transformer sensors are provided as shown. Special models or mountings are also available upon request.
|24 kVA 100A
400A max continuous
|24 kVA 100A
>200A max continuous
|36 kVA 150A
600A max continuous
|360 kVA 1500A rated|
|NGV24 un-switched version
210V, 220V, 230V, 240V
|NGV24-SW switched version
110/220V, 115/230V, 120/240V
|Use when measuring load on two individual wires is not needed, OR for power systems that are NOT split-phase such as in the following countries: Argentina, Australia, Austria, Belgium, Brazil, Chile, Denmark, Finland, Germany, Greece, Grenada, Guadeloupe, Haiti, Hong Kong, Iceland, Ireland, Israel, Italy, Jordan, Kenya, Kuwait, Luxembourg, Malaysia, Mexico, Montserrat, Netherlands, New Zealand, Norway, Paraguay, Peru, Poland, Portugal, Qatar, St. Kitts & Nevis, St. Lucia, St. Vincent, Sweden, Switzerland, Turkey, U.K., Uruguay.||Use when measuring of load on two individual wires of split phase system such as in the following countries: Bahamas, Belize, Bermuda, Bolivia, Canada, Cayman Islands, Columbia, El Salvador, Guam, Guatemala, Jamaica, Japan, Nicaragua, Panama, Philippines, Puerto Rico, Trinidad & Tobago, USA.|
Split core sensors can be installed without disconnecting power cables. These are particularly useful if you want to monitor an existing electric service without having to disconnect the main power cables to install the sensors.
For applications in other countries not listed above contact us if you need assistance selecting the proper meter.
Are YOU ready for the next power outage?
1 Video Introduction
2 Outage Archives
3 Utility Industry
4 Why You Need Backup
5 Personal Stories
6 NoOutage Configurations
8 Sizing for Your Needs
9 Voltage Drop Calculator
10 Test Reports
11 Placing Order
12 Equipment Leasing
13 Books & Videos
15 Frequently Asked
16 Future Technologies
17 Electricity Glossary
18 Help with Plug Types
19 Who We Are
20 Why Buy Here
21 Our Customers
22 Pick a Contractor
23 Privacy Promise
24 Safe Shopping Guarantee
25 Terms & Conditions
26 What's New
27 Contacting Us
28 Parts Lookup
29 Parts & Service
30 Made in USA
We welcome your feedback or questions. Click here to contact us.
See our Terms & Conditions before using information or ordering from this web site.
Copyright © 1999-2016 NoOutage.com LLC. All rights reserved.