Page last updated Oct 20, 2021 @ 10:14pm

OTEC125

Onan-OTEC.jpg (34073 bytes) Onan-OTECSE.jpg (15677 bytes)
typical photos service entrance rated specs
Click thumbnail image above to enlarge

Automatic Transfer Switch
125 amp 3 pole
with PowerCommand microprocessor control

 

The OTEC Open Transition Transfer Switch by Cummins Power Generation provides dependable load transfer for emergency and standby applications.  Featuring an easy-to-use microprocessor-based control panel, this switch provides reliable and cost-effective load transfer between a utility service and generator set.

Standard Features

* Open transition load transfer with selectable phase check or programmed transition.
* 3-phase voltage sensing on the normal source; single phase sensing on the generator.
* Front panel indicators and push buttons for ease of set-up.
* Simple-to-read control panel that features universal symbols for easy status recognition.
* Adjustable time delays.
* Integral exerciser clock.
* UL/NEMA 1 indoor enclosure.
* UL Listed and CSA Certified.

Optional Features

* Service entrance rated disconnect
* Fully programmable exerciser clock.
* Elevator signal relay.
* Battery chargers.
* UL/NEMA 3R, 4, 12 enclosures.

Single Phase

Cummins OTEC 125A and 225A 3 phase switches can be reconfigured in the field by the user for single phase by modifying settings on the controller.

Specs

Switch Current Rating 125 amps
Poles 3 pole with solid neutral
Voltage Rating 600Vac maximum
Transfer Time 6 cycles max at 60Hz with nominal voltage applied to actuator (without delayed transition enabled)
Operating Temperature -22F to +140F (-30C to +60C)
Operating Humidity 95% relative humidity, non-condensing
Altitude up to 10,000 feet without derating
Control Features (see notes below)

All setting adjustments are made by moving a slide switch on the back of the controller and using the touch pad on the front of the controller while observing the LEDs.  Detailed instructions contained in Owner Manual section 7.3.2.

KEY:
P.U. = pickup
D.O. = dropout
Function Adjustable Range Factory Setting
start time delay1 0-10 sec adj 3 sec
transfer time delay2 0-300 sec adj 5 sec
retransfer time delay3 0-30 minutes adj 10 minutes
stop/cool down delay4 0-30 minutes adj 10 minutes
neutral position delay
(600A switch & above)
0-64 sec 10 sec
under voltage sensing of utility5 70-90% D.O. adj
90-95% P.U. adj
85% D.O.
90% P.U.
frequency sensing of utility  ---  ---
voltage sensing of generator (1 leg) 75% D.O.
90% P.U.
 
frequency sensing of generator 75% D.O.
90% P.U.
 
generator test with or without load without
generator exercise with or without load
7-28 days
without
28 days
Options Included - 2 amp battery charger
- Two contacts (one for each source) are provided for customer use. Wired to terminal block for easy access. Rated at 10A continuous and 250 Vac maximum.
Other Options Available at additional cost
(partial listing)
- 40A, 70A, 125A, 150A, 225A, 260A, 300A,
   400A, 600A, 800A, 1000A ratings
- 120VAC through 600VAC
- 4 pole with switched neutral
- 50Hz
- 3 phase 3 wire or 4 wire
- type 3R, 4, 12 enclosures
- service entrance rated disconnect (through 800A)
Lug Capacities see spec sheet above
Enclosure UL type 1 indoor (types 3R, 4, 12 optional)
Nominal Dimensions (H x W x D) see spec sheet above
Weight see spec sheet above

NOTES:
1The start time delay prevents nuisance generator starts during momentary utility power variations.
2Transfer time delay allows generator set to stabilize before load is applied.
3Retransfer delay prevents needless power interruption if return of utility power is momentary.
4Stop delay allows gradual generator set cool down.
5Undervoltage sensing of utility supply provides reliable starting of generator set during brownout conditions.

This switch is available with service entrance rating as an optional adder.  Without this option you normally will need a service entrance rated disconnect between this switch and your power company meter.

 

 

 





Item Number: OTEC125
Price: $1,647
Price last updated 6/9/2022
Shipping Weight: 82 lbs.
This item normally ships in approximately 20 weeks or less.

   

Are YOU ready for the next power outage?

 1 Videos
 2 Outage Archives
 3 Utility Industry
 4 Why You Need Backup
 5 Personal Stories
 6 NoOutage Configurations
 7 Safety
 8 Sizing for Your Needs
 9 Voltage Drop Calculator
10 Test Reports
11 Placing Order
12 Equipment Leasing
13 Books & Videos  
14 Financing
15 Frequently Asked
16 Future Technologies
17 Electricity Glossary
18 Help with Plug Types
19 Who We Are
20 Why Buy Here
21 Our Customers
22 Pick a Contractor
23 Privacy Promise
24 Safe Shopping Guarantee
25 Terms & Conditions
26 What's New
27 Contacting Us
28 Parts Lookup
29 Parts & Service
30 Made in USA
31 Links

We welcome your feedback or questions.  Click here to contact us.
See our Terms & Conditions before using information or ordering from this web site.
Copyright 1999-2022 NoOutage.com LLC.  All rights reserved.