click thumbnail image above to enlarge
Page last updated Oct 20, 2021 @ 10:11pm
1-TWA-10-02
click thumbnail image above to enlarge
45' Guyed Tower Kit
for AIR Wind Generators
Tower kit for AIR wind generators. All guy wires attach to four anchor points. Tower tilts at base for easy installation and maintenance of generator from ground level. Kit includes hardware, guy wire, base, couplers and instructions. Pipe, tube, anchors and lift line not included. Purchase auger type anchors separately.
Pipe requirements are as follows: Use 1-7/8" outside diameter steel tubing which is the same as trade size 1-1/2" nominal inside diameter. A wall thickness of 0.065" will withstand 90 mph winds, a wall thickness of 0.090" will withstand 100 mph winds and a wall thickness of 0.145" will withstand 120 mph winds. Select tubing with appropriate wall thickness for your site.
These towers are P E stamped and approved for California buy-down program.
See Tower Details page for installation and construction information.
Detailed Parts List
| Part Description | Quantity |
| Base Connector | 1 |
| Upper Wire Set (280 ft pre-cut) | 1 |
| Lower Wire Set (160 ft pre-cut) | 1 |
| Base Staples | 2 |
| 3/8" x 1-1/2" Bolt | 3 |
| 3/8" Locknut | 3 |
| Cable Thimbles | 8 |
| Cable Clamps | 16 |
Item Number: 1-TWA-10-02
Price: $410
Price last updated 10/15/2015
Shipping Weight: 29 lbs. - dimensions 27x15x5 inches
This item normally ships in approximately 1 week or less.
Are YOU ready for the next power outage?
We welcome your feedback or questions. Click here to contact us.
See our Terms & Conditions before using information or
ordering from this web site.
Copyright © 1999-2024 NoOutage.com LLC. All rights reserved.
